FEATURES:

BROADBAND: No tuning requirements 87 to 108 MHZ.

HIGH GAIN: Only 5-7 watts drive for rated power output.

COMPACT: Occupies only 5 1/4" of 19" rack space.

DESIGNED FOR "LOCAL" AND "REMOTE" OPERATION: Momentary connection to ground permits "Start" , "Stop", and "Reset" functions, as well as all front panel readings at "remote" location.

FULL METERING: Front panel indicates voltages and currents of all pallets, as well as "forward" and "reflected" power outputs.

PROTECTED AGAINST VSWR, HIGH TEMPERATURE, AND OVERDRIVE: "Foldback" circuitry automatically reduces RF drive when VSWR exceeds 1:5:1. In addition, protection circuits turn off the amplifier if VSWR exceeds 2:1, or RF drive exceeds preset level, or if thermostats within equipment operate. Thermostats are located on each of the (2) pallets and combiner reject load.

OUTPUT RATING IS VERY CONSERVATIVE: Both amplifiers utilize 350 watt pallets that incorporate Phillips BGY278mosfets. The SSA-100, 150 and 300 use one pallet while the SSA-500 uses two pallets.

INSENSITIVE TO LINE VOLTAGE VARIATIONS: The amplifier contains independent switching power supplies that work at line voltages of 100 to 250 VAC. These supplies are very light weight and occupy a minimum volume.

SSA-100C/150C/300C	SSA-500C

TECHNICAL SPECIFICATIONS

POWER OUTPUT: SSA-100C - 100 WATTS, SSA-150C - 150 WATTS                                  SSA-300C - 300 WATTS, SSA-500C, - 500 WATTS  FREQUENCY RANGE (NO TUNING REQUIRED): 88-108 MHz RF DRIVE REQUIRED FOR RATED OUTPUT: 5-7 WATTS RF OUTPUT IMPEDANCE: 50 OHMS (TYPE "N" CONNECTOR) AM NOISE: LESS THAN 60 DB BELOW CARRIER FM NOISE: EQUAL TO EXCITER SOURCE

HARMONIC LEVEL: 80 DB BELOW CARRIER LEVEL POWER CONSUMPTION: SSA-100C @ 100W OUTPUT - 150W SSA-150C @ 150w OUTPUT  - 250W SSA-300C @ 300W OUTPUT - 495W SSA-500C @ 500W OUTPUT - 900W LINE VOLTAGE: 100 TO 250 VAC; SINGLE PHASE 50/60 HZ (SPECIFY) MECHANICAL SPECIFICATIONS NET WEIGHT: SSA-100C - 30 LBS. SSA-150C - 30 LBS., SSA-300C - 32 LBS., SSA-500C-34 LBS.