VSWR Foldback/Temperature Protection: Each mosfet utilized in the transmitter is protected by its own thermal protection circuitry. In addition each 1kW amplifier is also protected by a VSWR foldback circuit.

Commonly Available Parts: Built with your best interest in mind, the Legend Series "C", like all Energy-Onix Transmitters, is designed for years of reliable service and utilizes commonly available parts. On those rare occasions when parts replacement is necessary, you have control of where parts are purchased. This will allow you to shop local part suppliers for the best price. It also will speed replacement time putting you back at full power much sooner than you would be if you had to wait for high price, single source, proprietary items. Should you choose to purchase parts directly from us, we do offer next day delivery or next flight out service. Energy-Onix engineering department is available around the clock to assist with technical and parts support. The most important message to you is that our relationship will be a relationship you choose, not one forced on you.

Design Philosophy: The Legend Series “C” is built utilizing a “building block approach”. The basic building block is a conservatively rated 1kW PA drawer. These PA’s are then combined together to achieve the rated transmitter power output.

Internally each PA contains four BLF278 mosfets mounted on copper plates, which in turn are mounted on a massive heat sink. This system of heat dissipation along with our exhaust fans ensure cool operating temperatures for extended life.

16-18 watts of RF drive is required to achieve the 1kW PA output with each device output being combined by a 4:1 combiner.

Air Circulation: Cooling is achieved by having filtered air enter the cabinet through the rear filtered panels. This air is forced by independent muffin fans to pass through the fins of the heat sinks upon which the mosfets are mounted. This air is then forced out of the front of the chassis into the exhaust air plenum formed by the front "see through" door, and exhausted out of the cabinet by fans located on the rear door.

Control System: The Legend Series “C” has a straight forward, easy to use control system. Your Legend Transmitter can be started by local or remote control. Simply initiate the start button and within seconds you will be on the air.

Circuit Breaker & Fuse Protection: Each Legend System contains a circuit breaker panel for the incoming AC power as well as independent fuses for the independent power amplifiers. Front panel indicator lights describe the status of all fuses.

Monitoring: The Legend Series “C” has monitoring available of all transmitter parameters. Individual pallet current and combiner power output is available on each 1kw drawer. Overall transmitter readings for both incident and reflective power output are located on the front panel “Controller” drawer. Status of all fuses are present on the front panels of all power supplies.

Remote Control: No special interface is required. Simply apply a momentary ground to start, stop and reset the equipment.

RF Harmonics: At least 80db below carrier

AM Noise: At least 60db below carrier

FM Noise: At least 80db below 100% mod. at 400 Hz

Cabinet Size: 66 “ H x 23 “ W x 36” D

Cabinet Weight: 500 lb.

Power Consumption: 2.8KW @ 2KW Output

Line Voltage: 220 V Single Phase

Output Flange: 7/8” EIA